Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in ASA or PETG for the garden. Prints flat as a plate, no supports.
PETG with 3 walls; add a 5 V mini pump and 6 mm tube. Prints as shown on its floor, no supports.
Print diagonally or in two halves on a small bed. Prints as shown on its floor, no supports.
PETG 1.6 mm so it follows the body; wipe clean after use. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pegs: 6 to 20 mm dowel cut 40 mm long. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print with 4 walls so the post stays stiff. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the post with 4 walls. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.