Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold paint and screws on a ladder
Sits on top of a stepladder: one half takes a paint tin or a tub of filler, the other has bays for screws and a pencil, and grip feet stop it sliding off while you work.
Printing notes
178.2 cm³
Volume
221.0 g
Est. weight
2,916
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Carry secateurs on your belt
Carry secateurs blade-down on your belt: thread the belt through the two slots in the back, and a drain hole lets sap and rain run out.
Printing notes
9.1 cm³
Volume
11.2 g
Est. weight
4,352
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold RC cars with wheels free
A work stand for 1:10 RC cars: set the car on top so its wheels spin free while you tune the motor or change tyres, and carry it to the track by the hand holes. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
48.3 cm³
Volume
59.9 g
Est. weight
2,324
Triangles
Print floor-down as shown, then turn it over to use it. Large holes in the walls may need supports or good bridging.
MAIN PURPOSE: Hold a spray gun while filling
Holds a gravity-feed spray gun upright with its cup level, so you can fill and strain the paint with both hands free; the handle drops into the front notch.
Printing notes
45.8 cm³
Volume
56.7 g
Est. weight
1,116
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store small parts with easy scoop access
A deep parts bin with a low front, a scooped inner front edge that funnels parts to your fingers, and a label slot.
Printing notes
52.2 cm³
Volume
64.8 g
Est. weight
1,234
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store a rafter speed square
A tray with a recess shaped exactly like a 7-inch rafter square, so it always goes back in the same place.
Printing notes
439.7 cm³
Volume
545.2 g
Est. weight
1,224
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a multimeter and its probes
A deep fitted caddy for a multimeter with a long channel beside it for the test probes and leads.
Printing notes
313.4 cm³
Volume
388.7 g
Est. weight
1,772
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store wire strippers in a drawer
A thin shadow board for a tool drawer with a recess shaped like a pair of wire strippers.
Printing notes
101.2 cm³
Volume
125.5 g
Est. weight
748
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Organise a ratchet and sockets
A shadow tray with a ratchet-shaped recess and a row of four sockets in rising sizes.
Printing notes
272.0 cm³
Volume
337.3 g
Est. weight
2,716
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store small parts in a Gridfinity bin
A long Gridfinity bin with a scooped front edge for small parts and a label slot.
Printing notes
35.2 cm³
Volume
43.6 g
Est. weight
2,254
Triangles
Prints as shown on its floor, no supports.