Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print two in TPU. Print floor-down as shown, then turn it over to use it.
Print two in TPU or PETG. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print four in TPU. Prints flat as a plate, no supports.
Prints flat as a plate, no supports.
Print floor-down as shown, then turn it over to use it.
Print lying on its side, or as it comes. Prints as shown on its floor, no supports.
Print in PETG and rinse well before it goes in the tank. Print floor-down as shown, then turn it over to use it. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print with 100% infill and check against calipers. Prints as shown on its outline, no supports.