Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG. Prints flat as a plate, no supports.
Print in ASA or PETG for outdoors. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print four in TPU or PETG. Print floor-down as shown, then turn it over to use it.
Print floor-down as shown, then turn it over to use it.
Print in PETG with 5 walls; not for load-bearing handrails. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Prints flat as a plate, no supports.
Print in PETG and use 3 mm cord; knot the cords inside each hole. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.