Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Charm stems push into the floor holes; hang it through the keyholes or stand it on a shelf. Prints as shown on its floor, no supports.
Slots take standard graded slabs about 7 mm thick. Prints as shown on its floor, no supports.
The round pot holds styptic powder in case a nail bleeds. Prints as shown on its floor, no supports.
Brush both walls with release oil, pour fine concrete into the gap, cure 48 hours, then flex the mould off. Prints as shown on its floor, no supports.
The lid keeps the sand soft between sessions; the side garage holds moulds and tools. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in white; each bay's name is in the matching colour. Prints as shown on its floor, no supports.
Drop toy bones in, pour plaster with a little sand, leave 24 hours, then lift the block out by the lid and dig with a brush. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Rows fit floats up to 280 mm; wrap the delicate tips in foam if you like. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.