Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
One number per bay; the last two bays take the small candles and a lighter. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in orange with the pumpkin in black. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Screw it to the coop wall at back height; fill the left side with grit, the right with crushed oyster shell. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Write each name on a lolly stick, stand them in PICK; once a name is picked it moves to DONE until everyone has had a turn. Prints as shown on its floor, no supports.
Write the due date on a card in the label slot; every library book lives here when it isn't being read. Prints as shown on its floor, no supports.
The card stands in the slot on the stage; tuck a folded note under the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the drained floor of the sponge cup lets slip run off. Prints as shown on its floor, no supports.
Drop 7 cm nursery pots into the bays; the back row sits higher so every flower shows. Prints as shown on its floor, no supports.
ASA or PETG; lay it with the hood facing away from the weather and run the cords through the side ports. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Lay coated paper on the floor, leaves on top, then a 2 mm glass sheet on the ledges; expose 10-15 minutes in sun. Prints as shown on its floor, no supports.