Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The round pot holds styptic powder in case a nail bleeds. Prints as shown on its floor, no supports.
For dwarf species, glue fine mesh behind the vents. PETG takes the damp better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Bird-safe use: print in natural PLA, check for loose strings each week and remove if chewed sharp. Prints as shown on its floor, no supports.
PETG; hose it out after use. Prints as shown on its floor, no supports.
Add a pinch of calcium powder, drop in the crickets, cap it and shake gently. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG or TPU edge; print flat.
Print in a calm neutral; the lidded neck prints as one piece. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
PETG; print a handful. Prints as shown on its floor, no supports.
PETG; drop in a stainless nut so it sinks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; matt stone-coloured filament looks most natural. Print floor-down as shown, then turn it over to use it.