Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Scoop, shake over the sand, then move the keepers into the three side bays. Prints as shown on its floor, no supports.
White PETG stays cooler in the car than black. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Pack cotton wool with petroleum jelly as tinder; the twist-lock lid keeps it dry. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG or ASA outdoors; the perforated floor drains splashes. Prints as shown on its floor, no supports.
PETG, 3 walls; PTFE tape on the thread. Test it with your keys first. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints flat as a plate, no supports.
Translucent white PETG, 1.6 mm walls. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Thread 15 cm of thin cord with an M8 nut as the plumb. Prints flat as a plate, no supports.
Print in bright PETG so it floats into view in a bucket. Prints flat as a plate, no supports.