Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Thread three to five fishing lines (0.3-0.8 mm) through the end holes, over the two bridges, and tie them off; tune them all to the same low note. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Slide the phone in face up through the slot, stretch cling film drum-tight over the top and sprinkle a pinch of salt on it. Prints as shown on its floor, no supports.
Fill with a handful of 4.5 mm steel BBs (or dry lentils for a softer sound), then screw the lid on. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Cover the labels with a label protector; fill the wash bath with record cleaner and the rinse with distilled water. Prints as shown on its floor, no supports.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits standard valve oil bottles up to 32 mm. Prints as shown on its floor, no supports.
Print lid and drum flat; a drop of glue on the thread once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Thin walls resonate best: two perimeters, 10 % infill. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
TPU feet or the grip base stop it creeping. Prints as shown on its floor, no supports.
PETG or PLA; planks and peg print solid. Prints as shown on its outline, no supports. Stacked parts are fused into one print.