Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use with guidance from a physiotherapist or occupational therapist. A 290 x 125 mm sheet of 3 mm acrylic mirror slides into the centre slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Trace one side per four slow counts: in, hold, out, hold. Four laps is about a minute. Prints as shown on its floor, no supports.
Silicone and glass cups both fit; the bays run from the largest cup to the smallest. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as it comes (profile on the bed) in PETG.
Print diagonally or in two halves on a small bed. Prints as shown on its floor, no supports.
PETG 1.6 mm so it follows the body; wipe clean after use. Prints flat as a plate, no supports.
Fits bottles up to 24 mm across. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.