Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Paint the facades before closing; battery LEDs only. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print flat; print 100 %, 75 % and 55 % widths for three tiers.
Print in two colours with a filament swap at 30 mm. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the drawer in a contrasting colour. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print as it comes; rootlets print solid.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits a 6 x 4 inch landscape photo. LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print standing as shown; the 4 mm wall is solid. Prints as shown on its outline, no supports.