Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG with 5 walls; not for load-bearing handrails. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print in PETG and use 3 mm cord; knot the cords inside each hole. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Holes print a little small; open each one with the matching drill bit for a true reading. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Check the socket fits your light; print in PETG or ASA. Prints as shown on its floor, no supports. Stacked parts are fused into one print.