Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Label cheeses on a board
Little stakes that name each cheese on a board: push one into the rind and change the raised word for Brie, Cheddar or whatever you serve.
Printing notes
1.1 cm³
Volume
1.3 g
Est. weight
1,628
Triangles
Print a set. Prints flat as a plate, no supports.
MAIN PURPOSE: Hold rice paddle and measuring cup
Hang it beside the rice cooker: the paddle stands in the narrow slot, the measuring cup in the wide bay, and both drain through holes in the floor.
Printing notes
51.4 cm³
Volume
63.8 g
Est. weight
1,844
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold oysters steady while shucking
Shucking without the tea towel: the oyster sits cupped side down in a shell-shaped recess that stops it skidding while you work the knife into the hinge, and grip feet hold the cradle to the board.
Printing notes
282.6 cm³
Volume
350.4 g
Est. weight
1,484
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Build a stackable honeycomb wine rack
One cell of a honeycomb wine rack: print several, lay them on their sides and stack them. The bottle slides in neck first, its shoulder resting against the end wall while the neck pokes through.
Printing notes
115.9 cm³
Volume
143.7 g
Est. weight
236
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Butter bread easily with one hand
For anyone cooking with one hand: push a slice of bread into the raised corner and it stays put while you spread it. Grip feet stop the board sliding.
Printing notes
176.9 cm³
Volume
219.3 g
Est. weight
84
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Help one-handed eaters scoop food
A plate for eating one-handed or with a weak grip: food pushed towards the tall, curved back wall rolls up onto the spoon instead of off the edge, and grip feet hold the plate still.
Printing notes
146.5 cm³
Volume
181.6 g
Est. weight
1,678
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Support a loaded paper plate
A rigid holder for a 23 cm (9-inch) paper plate at picnics and barbecues, so a loaded plate never folds in your hand.
Printing notes
117.4 cm³
Volume
145.5 g
Est. weight
680
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Serve olives and catch the stones
An oval olive dish with a second wall inside it: olives sit in the middle and the stones drop into the channel that runs all the way round.
Printing notes
120.3 cm³
Volume
149.2 g
Est. weight
1,008
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Serve sushi with soy and wasabi
A low serving board on raised feet, with two small wells at one end for soy sauce and wasabi and softly rounded rims.
Printing notes
104.3 cm³
Volume
129.3 g
Est. weight
2,976
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Serve cheese with its own knife
A solid-looking serving board with a cheese knife shaped recess along the front edge, so the knife always has its place.
Printing notes
501.1 cm³
Volume
621.3 g
Est. weight
5,352
Triangles
Prints as shown on its floor, no supports.