Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Food-safe PETG; the basket sits inside the jar and you lift it by its rim to drain the pickles. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Each bay fits a 75 mm mooncake; print in red or gold and line with paper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the cover, turn it over the cheese; the flat lid is the board underneath. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Print the turntable ring in a contrasting colour and drop in 6 mm balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Food contact: line the bays or use food-safe PETG and wash by hand. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid keeps leftovers in the fridge in the same tray. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG; keep it away from the window. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Drop in three nursery pots up to 9 cm; give it a third of a turn every morning. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
The ring cup fits gourds up to 80 mm across the base. Prints as shown on its floor, no supports. The added base's lid prints separately.
Slide paper labels into the drawer-front slots. Prints as shown on its floor, no supports. The 4 drawers print separately from the case.