Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Line the inside of the curve with kitchen foil or aluminium tape, then stand the router's antenna up through the hole at the focus. Prints as shown on its outline, no supports.
Melt beeswax with a little crayon or charcoal for colour and pour it 3 mm deep. Sharpen a chopstick to a point for the stylus. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Slide a 125 x 160 mm sheet of 2 mm clear plastic down the slot behind the window. Hang it on the wall by the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
They print as two separate pieces. Lay one curve above the other, then swap them over. Prints as shown on its outline, no supports.
Prints flat. The bays are 168, 105, 63, 42 and 21 mm squares. Prints as shown on its floor, no supports.
Prints as one piece with no supports. Tall gear for pens, middle for scissors and rulers, short for clips. Prints as shown on its outline, no supports.
Print the pot and the turntable ring; drop a few ball bearings or a dab of grease between them for a smooth spin. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints flat with no supports. The gate leads into the front room. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.