Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print it as it comes out: disc flat on the bed, flange standing up, no supports. Use 4 walls (perimeters) so the joint between disc and flange is solid. Screw it on through the two 4.5 mm holes with 4 mm wood screws, or stick the flange on with strong double-sided foam tape (VHB type).
Prints as shown on its outline, no supports.
Print some bins mirrored: the hat tiling uses both hands. Prints as shown on its outline, no supports.
Fits pencils up to 19 cm. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.