Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The big bay takes most smart-ring charging docks; the cable leaves through the back. Prints as shown on its floor, no supports.
Fits 12.7 x 28 cm pop-up foils; screw it to the trolley through the keyholes. Prints as shown on its floor, no supports.
Print in turquoise, gold or deep blue. Prints as shown on its outline, no supports.
Mount with keyholes on screws or stick-on hooks; the slotted floor drains. Prints as shown on its floor, no supports.
Magnets go in the right-hand bay away from the pins, so they don't clump together. Prints as shown on its floor, no supports.
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.
Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Mount at adult height; wash the spacer as your nurse advises and let it dry in the tube. Prints as shown on its floor, no supports.
Use the screw lid when travelling; rinse the cup daily. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.