Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Fill with oats, lavender, chamomile or rose petals; hang it from the tap by the ring on its tower while the bath runs. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG. Fits a waterproof A6 notepad (or a slate of white plastic and a grease pencil). Screw it up through the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Mount with keyholes on screws or stick-on hooks; the slotted floor drains. Prints as shown on its floor, no supports.
PETG. Print flat.
Print as it comes (profile on the bed) in PETG, 40% infill.
Add a 20 x 3 mm magnet and a steel bottle cap. Prints as shown on its floor, no supports.
Print as it comes (profile on the bed) in PETG; fix with waterproof tape.
Fits a tumbler 80 mm or wider. Prints as shown on its floor, no supports.
PETG with 3 walls so it stays watertight. Prints as shown on its floor, no supports.
Print flat in PETG; it flexes round the trap.