Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Print two in TPU or PETG. Print floor-down as shown, then turn it over to use it.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as it comes, side outline on the bed; lay it down to use it.
Print in PETG with 4 walls so the fingers flex without snapping. Prints as shown on its outline, no supports.
Print as it comes; lay it on its long edge beside the stone.
Set the plate thickness (Wall) from 1 to 5 mm and print a set. Prints flat as a plate, no supports.
Print flat in PETG.
Print lying flat so the layers run along the hook.