Models Showcase

PETG. Let the dog watch you load it the first few times; supervise and put it away after play. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Cut corrugated cardboard into 40 mm strips and stand them on edge, packed tight; flip them when worn. Prints as shown on its floor, no supports.

Fill the box with fleece strips and scatter kibble; the deck makes the dog work with its nose. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Hang it inside the tank rim; the slots let water flow but keep adult fish out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Screw it to the coop wall at back height; fill the left side with grit, the right with crushed oyster shell. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.

Weight the base with a few coins if your wands are long. Prints as shown on its floor, no supports. The added base's lid prints separately.

Thread a belt or the lead's waist strap through the back slots. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.

The round pot holds styptic powder in case a nail bleeds. Prints as shown on its floor, no supports.

For dwarf species, glue fine mesh behind the vents. PETG takes the damp better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Bird-safe use: print in natural PLA, check for loose strings each week and remove if chewed sharp. Prints as shown on its floor, no supports.