Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PLA, printed flat; print two for big walls. Prints flat as a plate, no supports.
Print on its end; 10 mm strips; join lengths end to end. Prints as shown on its outline, no supports.
PETG; pan-head screws so the T-heads ride over them. Prints as shown on its floor, no supports.
Print on its side (profile on the bed) in PETG.
Print on its side in PETG. Light display loads, about 3 kg a pair.
Print two. PETG. Screw both before hanging. Prints as shown on its floor, no supports.
Print two, flat on the bed; PETG. Prints as shown on its outline, no supports.
Print two; turn one round for the other end. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print upright; PETG. Long screwdriver through the post. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print on its end in PETG; print enough lengths to span the shelf. Prints as shown on its outline, no supports.