Loom Bracket

Hang a textile on a dowel without visible ends

A pair of brackets for hanging a weaving, quilt or tapestry on a 20 mm dowel. The closed outer face hides the dowel end, the inner face has the bearing hole, and the same print works at both ends by turning it over; two screws each.

Customize this model

Size: 40 × 50 × 46 mm
Shape: Rectangular
Walls: 4.0 mm
Volume: 11.9 cm³
Est. weight (PLA): 14.8 g
Parts to print: 1
Category: Home hardware & architecture
Made by: Krypto
Built in: 18 steps

What’s in it

Rectangular, 40 × 50 × 46 mm, with 4.0 mm walls
3 holes in the floor and walls

How to print it

Print two; turn one round for the other end.

Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Filament: at most about 14.8 g of PLA printed solid (roughly $0.30 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the loom Bracket model?

The loom Bracket model measures 40 × 50 × 46 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

It may need supports in places. Print two; turn one round for the other end. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

How much filament does it use?

At most about 14.8 g of PLA (11.9 cm³ printed solid), roughly $0.30 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.