Twine Cleat

Anchor and tension a hanging line on the wall

A pair of wall cleats for a photo line, fairy lights or a garland. Screw one at each end through the cup in the boss, wrap the twine over the bar and round the two hooked horns in a figure of eight, and the line holds taut; unwrap it to re-tension or re-hang in seconds, with no knots to pick.

Customize this model

Size: 100 × 26 × 14 mm
Shape: Custom outline
Walls: 5.0 mm
Volume: 19.9 cm³
Est. weight (PLA): 24.7 g
Parts to print: 1
Category: Home hardware & architecture
Made by: Krypto
Built in: 7 steps

What’s in it

Custom outline, 100 × 26 × 14 mm, with 5.0 mm walls
Custom outline traced from a shape
1 hole in the floor

How to print it

Print two, flat on the bed; PETG.

Prints as shown on its outline, no supports.

Filament: at most about 24.7 g of PLA printed solid (roughly $0.49 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the twine Cleat model?

The twine Cleat model measures 100 × 26 × 14 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. Print two, flat on the bed; PETG. Prints as shown on its outline, no supports.

How much filament does it use?

At most about 24.7 g of PLA (19.9 cm³ printed solid), roughly $0.49 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.