Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print diagonally or in two halves on a small bed. Prints as shown on its floor, no supports.
PETG 1.6 mm so it follows the body; wipe clean after use. Prints flat as a plate, no supports.
Fits bottles up to 24 mm across. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pegs: 6 to 20 mm dowel cut 40 mm long. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.