Models Showcase

Print the lid face down. A snug fit stops the lid turning in a bag. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Drop a folded stack of tissues into the main box under the slotted top; the bin flap swings in and the bin's lid lifts off to empty. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.

Use with guidance from a physiotherapist or occupational therapist. A 290 x 125 mm sheet of 3 mm acrylic mirror slides into the centre slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Trace one side per four slow counts: in, hold, out, hold. Four laps is about a minute. Prints as shown on its floor, no supports.

Mount at adult height; wash the spacer as your nurse advises and let it dry in the tube. Prints as shown on its floor, no supports.

Use the screw lid when travelling; rinse the cup daily. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Silicone and glass cups both fit; the bays run from the largest cup to the smallest. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.

Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Print as it comes (profile on the bed) in PETG.