Models Showcase

Print in brown or grey with 4 walls. Screw the flat side to the wall so the open top is tight under the soffit, at least 2 m up. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

PETG for outdoors. An old phone running a free motion-triggered camera app works well; run the cable out under the lid. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.

Drop a 12 cm nursery pot inside; the ribs keep its sides cooler in full sun. Prints as shown on its floor, no supports.

Fill with 1 part sugar to 4 parts water, no dye; clean every 2-3 days. The red text attracts the birds. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Drop 7 cm nursery pots into the bays; the back row sits higher so every flower shows. Prints as shown on its floor, no supports.

Lay damp paper towel in each lane with 10 seeds, lid on, and count the sprouts after a week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Brush both walls with release oil, pour fine concrete into the gap, cure 48 hours, then flex the mould off. Prints as shown on its floor, no supports.

Keep 1-2 cm of rain or distilled water in the outer tray at all times; never tap water. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Put a sponge soaked in 1:4 sugar water in some petals and orange slices in others; refresh every two days. Prints as shown on its floor, no supports.

Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.