Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Display photos and postcards with pens
A long low stand with two thin slots that hold photos and postcards upright, and a trough behind for pens.
Printing notes
38.1 cm³
Volume
47.3 g
Est. weight
2,904
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Dock a smartwatch charging puck
A small dock with a round recess that holds the watch charging puck, a channel for its cable and an exit hole.
Printing notes
47.2 cm³
Volume
58.5 g
Est. weight
3,520
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep pens and markers visible in tiers
Three rows rising from a low front to a tall back, so every pen and marker stays visible.
Printing notes
156.3 cm³
Volume
193.8 g
Est. weight
1,016
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Carry your desk kit between desks
Carry your desk kit from desk to desk: two bays either side of a tall middle wall with a hand hole.
Printing notes
109.9 cm³
Volume
136.3 g
Est. weight
1,668
Triangles
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
MAIN PURPOSE: Protect surfaces from mug rings
A round coaster with a raised rim and large engraved initials.
Printing notes
24.0 cm³
Volume
29.7 g
Est. weight
1,944
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Display a rubber debugging duck
A small plinth for the rubber duck that listens to your code, with DEBUG on the front.
Printing notes
15.6 cm³
Volume
19.4 g
Est. weight
6,292
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Lean postcards and photos on a ledge
A narrow wall ledge with a low lip for leaning postcards, photos and small prints, with keyholes on the back.
Printing notes
34.4 cm³
Volume
42.6 g
Est. weight
2,500
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Protect a set of paperbacks
A slipcase for a set of paperbacks: open at the front so the spines show, with rounded edges.
Printing notes
146.0 cm³
Volume
181.0 g
Est. weight
3,060
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hang a power brick off the floor
An open-ended cradle for a laptop or monitor power brick that hangs on the desk leg, a back panel or the wall from two keyholes, keeping the brick and its cables off the floor.
Printing notes
19.3 cm³
Volume
24.0 g
Est. weight
1,532
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store small parts with easy scoop access
A deep parts bin with a low front, a scooped inner front edge that funnels parts to your fingers, and a label slot.
Printing notes
52.2 cm³
Volume
64.8 g
Est. weight
1,234
Triangles
Prints as shown on its floor, no supports.