Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Open tight bottle caps with less effort
Opens tight plastic bottle caps for anyone with a weak grip: push the tapered jaw over the cap until it wedges, then turn the long handle.
Printing notes
22.1 cm³
Volume
27.4 g
Est. weight
184
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Open ring-pull cans without hurting fingers
A keyring tool that lifts stiff ring-pull tabs on drinks cans and tins without breaking a nail: slip the hooked tip under the tab and lever up.
Printing notes
2.5 cm³
Volume
3.1 g
Est. weight
268
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Draw right angles and 45-degree lines
A 45-degree set square for technical drawing, model making and marking out: slide it along a ruler or a T-square for parallel lines, verticals and 45-degree angles.
Printing notes
35.8 cm³
Volume
44.4 g
Est. weight
1,272
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Roll dough to an even thickness
Lay one strip each side of the dough and roll the pin along them: the dough comes out exactly 5 mm thick, so cookies and pastry bake evenly.
Printing notes
24.0 cm³
Volume
29.8 g
Est. weight
2,468
Triangles
Print two; change the plate thickness for other sizes. Prints flat as a plate, no supports.
MAIN PURPOSE: Texture buttercream on cakes
Four different edges in one comb, sawtooth, square ridges, round grooves and plain, for patterned sides on buttercream cakes.
Printing notes
31.2 cm³
Volume
38.6 g
Est. weight
792
Triangles
Print in food-safe PETG. Prints flat as a plate, no supports.
MAIN PURPOSE: Space tiles evenly
Cross-shaped spacers that keep wall and floor tiles evenly apart while the adhesive sets, so the grout lines come out straight.
Printing notes
0.7 cm³
Volume
0.9 g
Est. weight
44
Triangles
Print a batch; the plate thickness sets the grout gap. Prints flat as a plate, no supports.
MAIN PURPOSE: Set even gaps between deck boards
Hang it over a joist between two deck boards: the 5 mm blade sets an even drainage gap while you screw the board down.
Printing notes
21.4 cm³
Volume
26.5 g
Est. weight
416
Triangles
Print flat; print four.
MAIN PURPOSE: Let pupils leave the classroom with a pass
A tough hall pass for school corridors: hang it on a lanyard through the hole, and the class name goes in the raised text.
Printing notes
31.1 cm³
Volume
38.6 g
Est. weight
8,792
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Candle eggs during incubation
Check hatching eggs for growth: slip the cup over a small torch or a phone light, rest the egg on the soft rim and look for veins and movement in a dark room.
Printing notes
16.5 cm³
Volume
20.4 g
Est. weight
848
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Support work for jewellery sawing and filing
Clamp it to the bench edge to support silver sheet and wire while you saw, file and drill; the V cut-out lets the saw blade pass right through.
Printing notes
44.4 cm³
Volume
55.0 g
Est. weight
476
Triangles
Prints as shown on its outline, no supports.