Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Fits standard cash envelopes about 175 x 90 mm; label the bays with the front slot. Prints as shown on its floor, no supports.
Snaps into any Gridfinity baseplate. Prints as shown on its floor, no supports.
Put a little sponge and cutting oil in the cup; the cutter wheel rests in it. Prints as shown on its floor, no supports.
Fits standard valve oil bottles up to 32 mm. Prints as shown on its floor, no supports.
Print in blue-grey or a silk filament. Prints as shown on its floor, no supports.
Thread two hook-and-loop straps through the side slots round the rollator seat frame. Prints as shown on its floor, no supports.
Fits 2-inch net cups; float or rest it on a dark tub and top up only once. Prints as shown on its floor, no supports.
Print in turquoise; sabzeh sprouts grow happily in the corner bay. Prints as shown on its floor, no supports.
Write the perfume name at the bottom of each strip before you spray. Prints as shown on its floor, no supports.
Run the seat's lap strap or a buckle strap through the side slots. Prints as shown on its floor, no supports.