Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The ring holds cans and cups up to 85 mm; flat base for laps and cushions. Prints as shown on its floor, no supports.
One tasting cup or gaiwan per numbered bay; note scores against the numbers. Prints as shown on its floor, no supports.
Give each child a named peg or token; check the board together at the start of the day. Prints as shown on its floor, no supports.
The phone stands inside on its side, filling the screen; the cable leaves through the back. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in clear or smoke grey for the full cassette look. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Cover the labels with a label protector; fill the wash bath with record cleaner and the rinse with distilled water. Prints as shown on its floor, no supports.
Blanks are 20 mm square by 130 mm; write the species on the label strip. Prints as shown on its floor, no supports.
Drop 7 cm nursery pots into the bays; the back row sits higher so every flower shows. Prints as shown on its floor, no supports.
Screw or tape it to the enclosure side; the slot takes scrapers up to 8 mm thick. Prints as shown on its floor, no supports.
Fill through the base; tilt it and a marker drops out of the top hole. Prints as shown on its floor, no supports. Stacked parts are fused into one print.