Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Put a layer of pebbles in the planter bottom so the fern's roots never sit in water. Prints as shown on its floor, no supports.
Print in brown or grey with 4 walls. Screw the flat side to the wall so the open top is tight under the soffit, at least 2 m up. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Use with guidance from a physiotherapist or occupational therapist. A 290 x 125 mm sheet of 3 mm acrylic mirror slides into the centre slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
PETG. Let the dog watch you load it the first few times; supervise and put it away after play. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in white so the grid shows. Use 50 ml of liquid per bay and the same brand of bear in each. Prints as shown on its floor, no supports.
PETG. Fits a waterproof A6 notepad (or a slate of white plastic and a grease pencil). Screw it up through the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.