Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright in PLA or PETG with no supports. Use 3 walls (perimeters) for a sturdier box. Prints as shown on its floor, no supports.
Print it as it comes out: disc flat on the bed, flange standing up, no supports. Use 4 walls (perimeters) so the joint between disc and flange is solid. Screw it on through the two 4.5 mm holes with 4 mm wood screws, or stick the flange on with strong double-sided foam tape (VHB type).
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
For deep drawers: table knives need about 220 mm inside. Stand it on a drip mat. Prints as shown on its floor, no supports.
Use a multi-port USB charger, leave slack in its lead so the drawer opens fully, and don't shut away a charger that runs hot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Engrave in a contrasting colour by changing filament at the floor top. Prints as shown on its floor, no supports.
Press or glue a 10 mm disc magnet into each seat from below. Prints as shown on its outline, no supports.
Print in PETG for the bath. Let it dry upside down. Prints as shown on its outline, no supports.
Cut the glass or acrylic about 195 x 115 mm. Stand it on a saucer. Prints as shown on its floor, no supports.
Print three. Use 20 mm soft balls or rolled paper balls. Prints as shown on its floor, no supports.