Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Lay out the primaries at 12, 4 and 8 o'clock and mix the in-between wells. Prints as shown on its floor, no supports.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in black with the lid crack in gold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
White PETG stays cooler in the car than black. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Keep the lid on between sessions so the slime doesn't dry out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits standard valve oil bottles up to 32 mm. Prints as shown on its floor, no supports.
Pack safety pins, glue, magnets, Velcro, a mini sewing kit and spare makeup. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Silicone and glass cups both fit; the bays run from the largest cup to the smallest. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print each step in a bright papel-picado colour; LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.