Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Holes take 16 mm test tubes; the lower tray catches spills. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
PETG; hose it out after use. Prints as shown on its floor, no supports.
The long slot takes a 150 mm plexi scraper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; tip the drip tray out over a sink. Prints as shown on its floor, no supports.
Hang at child height through the keyholes; darts stand nose-up in the rows. Prints as shown on its floor, no supports.
Scoop, shake over the sand, then move the keepers into the three side bays. Prints as shown on its floor, no supports.
Read the notes together later, then tell your child the monster ate them. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.