Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Roll each belt and stand it in its bay from white on the left to black on the right. Prints as shown on its floor, no supports.
Stand the kit's pots in the numbered wells, or squeeze the paint straight into them. Prints as shown on its floor, no supports.
Needles go in the screw-top tube so they never end up in a toe pad. Prints as shown on its floor, no supports. The added base's lid prints separately.
Write the model and part numbers on the label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Thread a belt or the lead's waist strap through the back slots. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Labels are in the floor so children can match pieces to bays. Prints as shown on its floor, no supports.
Wrap the post in mirror film; draw on a printed polar grid laid on the board. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Cups fit boules up to 76 mm; the centre box holds the jack and a measuring tape. Prints as shown on its floor, no supports.
The cups take standard tape rolls; the box takes stick wax and a lace hook. Prints as shown on its floor, no supports.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.