Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Make wildflower seed bombs
Press a mix of clay, compost and wildflower seeds into the twelve cells, let them dry and pop them out; throw the seed bombs onto bare ground for a patch of flowers.
Printing notes
83.3 cm³
Volume
103.3 g
Est. weight
1,724
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store and reuse carrier bags
Stuff used carrier bags in at the top and pull them out one at a time from the opening at the bottom; it hangs on the wall or inside a cupboard door from the two keyholes.
Printing notes
39.4 cm³
Volume
48.9 g
Est. weight
2,168
Triangles
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
MAIN PURPOSE: Collect litter in an outdoor bin
A tall litter bin with an open dome top and LITTER on the back.
Printing notes
391.3 cm³
Volume
485.2 g
Est. weight
1,012
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
MAIN PURPOSE: Collect used batteries for recycling
A small dome-topped bin for used batteries, with BATTERIES on the back.
Printing notes
94.6 cm³
Volume
117.3 g
Est. weight
4,204
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.