Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as it comes (profile on the bed); the rib is solid.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Print open side down; 8 mm and 6 mm dowels. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; clean with alcohol before pouring agar. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
PLA, 1 mm; an M4 nut glued in the pocket. Prints flat as a plate, no supports.
Print upright. Prints as shown on its floor, no supports.
Deck on the bed. Print it as shown, then turn it over so the floor becomes the top. Needs ball chain and a mirror tile. Print floor-down as shown, then turn it over to use it.
Print eight, same settings so they weigh the same. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Tie a 60 cm cord through the centre hole. Prints flat as a plate, no supports.