Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Wedge it in a fast, shallow stretch of stream, riffles across the flow, and shovel gravel into the upstream end. Prints as shown on its floor, no supports.
PETG. Glue a 120 mm disc of 3 mm clear acrylic over the window with aquarium silicone. Prints as shown on its floor, no supports.
PETG or PP. Fill only the outer ring with water, freeze overnight, then dip in warm water and the ice slides out. Prints as shown on its floor, no supports.
PETG. Fill with water to 1 cm below the rim; push the magnetised needle through a thin slice of cork. Prints as shown on its floor, no supports.
Stand hackle and pheasant tail feathers in the tall box, quill-down. Prints as shown on its floor, no supports.
The perforated floor lets sand fall out; PETG copes with a hot car. Prints as shown on its floor, no supports.
Rows fit floats up to 280 mm; wrap the delicate tips in foam if you like. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Thread a 40 mm belt through the two back slots; PETG for mud and rain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
The long slot takes a 150 mm plexi scraper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.