Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Fill with fine dry sand or salt and hang it from a Y of string about 1 m long over dark card. Tape over the bottom hole until you let go. Prints as shown on its floor, no supports.
PETG; wipe dye off straight away. Twist the damp shirt flat round a fork in the centre circle, band it into six wedges along the ribs. Prints as shown on its floor, no supports.
Print in orange with the pumpkin in black. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the drained floor of the sponge cup lets slip run off. Prints as shown on its floor, no supports.
Rest the canvas on the raised inner ring; scrape the cured drips out of the moat and reuse them as paint skins. Prints as shown on its floor, no supports.
Glue a sheet of glass or acrylic in the slab bay for the smoothest roll-out. Prints as shown on its floor, no supports.
Fill through the base; tilt it and a marker drops out of the top hole. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Stand the kit's pots in the numbered wells, or squeeze the paint straight into them. Prints as shown on its floor, no supports.
Slots take acrylic rulers up to 16 mm thick; weight the base with a few coins if your rulers are tall. Prints as shown on its floor, no supports.
Lay out the primaries at 12, 4 and 8 o'clock and mix the in-between wells. Prints as shown on its floor, no supports.