Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Protect floors under casters
Stops chair and sofa casters rolling and scratching wooden floors: the wheel sits in the inner ring and the grip feet hold the cup still.
Printing notes
20.5 cm³
Volume
25.4 g
Est. weight
1,168
Triangles
Print four in TPU or PETG. Prints as shown on its floor, no supports.
MAIN PURPOSE: Make a skipping rope
Turn any 6-10 mm rope into a skipping rope: thread each end through a handle, tie a knot and pull it back inside; the round grips spin freely in the hand.
Printing notes
25.8 cm³
Volume
32.0 g
Est. weight
848
Triangles
Print two. Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a ball for place kicks
Holds a rugby or American football upright for place kicks on grass or artificial turf: the ball rests in the ring at the right height and angle.
Printing notes
64.9 cm³
Volume
80.5 g
Est. weight
1,008
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Blow soap bubbles
Dip the ring in bubble mixture and wave slowly for big bubbles; the long handle keeps sticky hands clear.
Printing notes
12.0 cm³
Volume
14.9 g
Est. weight
348
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Draw with pavement chalk
Holds a chunky stick of pavement chalk so little hands stay clean and the chalk doesn't snap; push the chalk up as it wears down.
Printing notes
17.9 cm³
Volume
22.2 g
Est. weight
848
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Count tablets accurately
A pharmacist-style counting tray: slide tablets across the flat deck in fives with a spatula into the channel, then pour them into the bottle through the corner notch.
Printing notes
42.2 cm³
Volume
52.3 g
Est. weight
1,076
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Guide two yarns in colourwork knitting
Wear it on a finger when knitting with two colours: each yarn runs through its own loop, so the strands stay apart and the tension stays even.
Printing notes
1.2 cm³
Volume
1.4 g
Est. weight
780
Triangles
Print a few sizes; TPU is the most comfortable. Prints flat as a plate, no supports.
MAIN PURPOSE: Hold stitches when knitting cables
A U-shaped cable needle that holds the stitches you set aside while knitting cables; the kink stops them sliding off the end.
Printing notes
5.9 cm³
Volume
7.3 g
Est. weight
408
Triangles
Prints as shown on its outline, no supports.
MAIN PURPOSE: Play in the bath
A little boat that floats in the bath or a paddling pool, with room for a toy figure on board; print it watertight and it sails all evening.
Printing notes
34.2 cm³
Volume
42.4 g
Est. weight
664
Triangles
Print with 3 walls and no gaps so it stays watertight. Prints as shown on its outline, no supports.
MAIN PURPOSE: Align model rocket fins for gluing
Holds three fins at exactly 120 degrees round a 24 mm body tube while the glue sets: slide the tube through the centre and the fins into the slots.
Printing notes
82.5 cm³
Volume
102.3 g
Est. weight
540
Triangles
Prints as shown on its outline, no supports.