Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG; add a strip of bike inner tube as the pad. Prints as shown on its outline, no supports.
Tie a 60 cm cord through the centre hole. Prints flat as a plate, no supports.
PETG with solid walls so it holds water; check the inside is 100 mm. Prints as shown on its floor, no supports.
Glue in 2 mm and 3 mm glass beads. Prints flat as a plate, no supports.
PETG, 3 walls; push a short drinking straw into the spout. Prints as shown on its floor, no supports.
White PLA, colour it with markers. Prints as shown on its floor, no supports.
PETG; matt stone-coloured filament looks most natural. Print floor-down as shown, then turn it over to use it.
Print six or more. Prints as shown on its floor, no supports.
Print one per track in each player colour; PETG springs best. Prints as shown on its outline, no supports.
Print a set per player in their colour. Print floor-down as shown, then turn it over to use it.