Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the belly or the neck in the editor, or add a wall pattern, to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size in the editor, or add a wall pattern, to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor, or add a wall pattern, to make your own.
Matte terracotta or stone-effect PLA makes it look like real pottery. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the curve in the editor, or add a wall pattern, to make your own.
Silk or gradient PLA makes the plain curve glow. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the curve in the editor, or add a wall pattern, to make your own.
Silk, marble or matte PLA all look good on the smooth surface; it prints quickly and uses little filament. Prints as shown on its floor, no supports.
Print it as shown, then turn it over: the floor becomes the roof. Lay a strip of white card on the ground inside with an ink pad (powdered charcoal in vegetable oil on a sponge) across the middle. Print floor-down as shown, then turn it over to use it.
Stretch a cut balloon, shower cap or plastic bag drum-tight over the open top and tape it all round. Tap the middle sharply. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
PETG; wipe dye off straight away. Twist the damp shirt flat round a fork in the centre circle, band it into six wedges along the ribs. Prints as shown on its floor, no supports.
Stuff it with straw or wood wool, push a cane through the hole and hang it upside down in the tree, open end down. Prints as shown on its floor, no supports.
Print one at 205 mm and four at 100 mm (change the width); the four small trays tile the big one, two of them flipped over. Prints as shown on its outline, no supports.