Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG with 4 walls. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Translucent white PETG, 1.6 mm walls. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG or ASA, 5 walls, 50 % infill. Prints as shown on its floor, no supports.
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Use an 8 mm dowel through the hub as the handle. Prints as shown on its floor, no supports.
White PLA for the screen wall; cap the finder scope. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG; print a handful. Prints as shown on its floor, no supports.
Print the plate on the bed, the post upright. Print floor-down as shown, then turn it over to use it.
Print two. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.