Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print several to stack. Prints as shown on its floor, no supports.
Print three per grow bag. Prints as shown on its floor, no supports.
Print several and tile them, rotated 90 degrees in turn. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print as many tiles as the window needs. Prints flat as a plate, no supports.
Add a 5 V USB LED strip about 15 cm long. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG with 3 walls; keep 2 cm of water in the chamber. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG, 1.6 mm, so it flexes; thread a cord or a dressing gown belt. Prints flat as a plate, no supports.
PETG; measure your knob, the cup is 56 mm inside. Prints as shown on its floor, no supports.