Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Two colours, food-safe PETG. Print it as shown, then turn it over so the floor becomes the top. The cap becomes the base. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Print four in food-safe PETG; the court takes a 90 mm square bowl. Prints as shown on its outline, no supports.
Print upright; arches bridge cleanly. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in PETG; check the 6.5 mm slot against your plate rim. Prints flat as a plate, no supports.
Food-safe PETG; for resting meat, not on the grill. Prints flat as a plate, no supports.
Print in TPU for extra grip. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
For food contact, print in a food-safe PETG and wash by hand. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.