Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
For packets up to 70 mm wide. Needs a drawer 120 mm deep, with a finger's width in front of the slots. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG. For very fine tea, line it with a paper filter. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print the drawer and the sleeve. The sleeve's flat top is the coaster; PETG takes a hot mug best. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Print the body and slotted top in clear PETG so the piles show. Swap the labels with paper stickers week by week. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
One tasting cup or gaiwan per numbered bay; note scores against the numbers. Prints as shown on its floor, no supports.
The large cup holds a 250 ml test jar steady; the slim tube keeps the hydrometer safe between readings. Prints as shown on its floor, no supports.
The round well fits a jebena base up to 105 mm; food-safe PETG. Prints as shown on its floor, no supports.
Food-safe PETG; keep it away from the window. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
The ring cup fits gourds up to 80 mm across the base. Prints as shown on its floor, no supports. The added base's lid prints separately.
Food-safe PETG. Print floor-down as shown, then turn it over to use it.