Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the cloud white and the cups blue. Prints as shown on its outline, no supports.
Print in purple for the classic T piece; it tessellates with other tetromino bins in a drawer. Prints as shown on its floor, no supports.
Print the tiers alternately red and white. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the hub white and the pods grey. Prints as shown on its floor, no supports.
Print in a tan or brown; a long sausage dog fits a row of pens nose to tail. Prints as shown on its outline, no supports.
Print in green or a marble filament for the shell. Prints as shown on its outline, no supports.
The quill shaft at the bottom is a handle for lifting it off the desk. Prints as shown on its outline, no supports.
Slots fit styluses up to 12 mm thick; the side box takes spare nibs and the nib remover. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
Print upright in PLA or PETG. Prints as shown on its floor, no supports.