Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hide cables and power strips
A lidded cable box with vent slots on the front, cable holes on both ends and rounded corners.
Printing notes
195.0 cm³
Volume
241.8 g
Est. weight
27,598
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Dock a phone while it charges
A phone dock with a low front for the screen, a cable hole at the back and rounded corners.
Printing notes
22.3 cm³
Volume
27.6 g
Est. weight
1,660
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hide a power strip and cables
A lidded box that hides a power strip, with cable holes on both ends.
Printing notes
186.0 cm³
Volume
230.6 g
Est. weight
1,520
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hide a power strip and chargers
A box with a lid and cable slots in both ends to hide a power strip and chargers.
Printing notes
275.1 cm³
Volume
341.2 g
Est. weight
1,476
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Separate new and used batteries
Eight compartments to keep new and used batteries apart.
Printing notes
47.6 cm³
Volume
59.0 g
Est. weight
4,036
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Park chargers, earbuds and a smartwatch
A rounded capsule tray in two halves for chargers, earbuds and a smartwatch.
Printing notes
64.4 cm³
Volume
79.8 g
Est. weight
620
Triangles
Prints as shown on its floor, no supports.