Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Deep red, gold or black silk PLA. Lid prints separately. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in white or pearl; feels good in silk PLA. Prints as shown on its outline, no supports.
Silk PLA; glue in a 50 mm round mirror with a dot of silicone. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print flat in PETG or silk PLA; sand the tips smooth.
PETG, 1.6 mm; print two per pair. Prints flat as a plate, no supports.
Print flat in PETG; add a 60 cm ribbon.
Print flat in PETG; white or clear hides best.
Print with 4 walls so the post stays stiff. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Print as it comes (profile on the bed) in PETG.