Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the belly or the neck in the editor, or add a wall pattern, to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor, or add a wall pattern, to make your own.
Matte terracotta or stone-effect PLA makes it look like real pottery. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the curve in the editor, or add a wall pattern, to make your own.
Silk, marble or matte PLA all look good on the smooth surface; it prints quickly and uses little filament. Prints as shown on its floor, no supports.
Stick a mirror tile on the floor, run a battery LED strip round the walls below the ledge, and lay a one-way-mirror acrylic sheet on the ledge. Prints as shown on its floor, no supports.
Print in gold or rose; engrave initials with a marker or a rotary tool on the body. Prints as shown on its outline, no supports.
The big bay takes most smart-ring charging docks; the cable leaves through the back. Prints as shown on its floor, no supports.
Fits 12.7 x 28 cm pop-up foils; screw it to the trolley through the keyholes. Prints as shown on its floor, no supports.
Print in turquoise, gold or deep blue. Prints as shown on its outline, no supports.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.